[talat]

nokia e73 не восстанавливается simlock rpl покупал uo5oq.com

лог best:

card found: S/N 2xxxxxxxx
registered to: asxxxx

Connect phone on selected interface...

Opening Connection...
Device Location: 00000021
Connect Ok!
Initializing Connection...
JAF Firmware: 01.B6

JAF S/N ODJAF000 boot - Ok
Switch jaf to FBUS...
FbusMode set Ok

Connect phone on selected interface...

Phone found!
Series 60 Device detected!
read info... - Ok

Reading Phone Info....
Connected phone - Nokia E73
Software ver : V ICPR82_10w22.13 25-03-11 RM-658 (c) Nokia
IMEI : 12345610654321?
Ape Ver : Error
DSP Ver : ICPR82_10w22.11
PPM :
CNT :
Product SN : 0
Product code : 0599015
Long Prod.SN : 0
Hardware info=======
HWID :
Retu : 40
Tahvo : 00
Batery: 4673 mV
RF ic : |Vapaus_5.1 | Mikki_1.1
Lock info ===========
IMEI : 12345610654321?
IMEI spNet :
IMEI svNet :

Unable to read Lock table...
User code : Crypted
UserDataExLevel : Low [Gallery] , FullFlash method

Done!

Will Write RPL keys now...
Check RPL file...
NPC Data found! (CMT)
CCC Data found! (CMT)
HWC Data found! (CMT)
SimLock Data found!
SimLock key found!
SuperDongle Key found!
CMLA key found!
WMDRM key found!
Checking BUS...
Switch jaf to FlashMode...
FlashMode set Ok
Booting phone...

BOOT 1ST : C0

CMT part info :
CMT ASICID : 000000030000022600010007600C192102011104
CMT EM0 ID : 00001040
CMT EM1 ID : 00001030
CMT PUB ID : 24D001173185034443A68C0C9FD987DBAB7B531B
CMT MODE ID : 00
CMT R_HASH : 25B977A055BE9B5DEC0C38A2A279C695
CMT ROM ID : 3E273BF637BE26FA

- > Change Protocol : NEW

Using NEW Flashing Protocol

CMT : Sending 2nd loader...
Use RAPUv11_2nd.fg , Rev : 3.0 Ver : 9.48.0
CMT Loader sent, Boot Ok
Trans Req : 32 bit, DualLine, Set : 32 bit, DualLine
CMT Flash ID : 005800EC < SAMSUNG [SEC] => KAV00Q009A [NAND]
FLIC : 005800EC , NAND , CMT

Sending Algo...
Use RAPUv11_XSR17_alg.fg , Rev : 3.0 Ver : 9.48.0
Finalize done, Algo sent!
Trans Req : 32 bit, DualLine, Set : 32 bit, DualLine
PapubKeysReq : 5A598961FC04496A97031F5F80A2D25CECCF557780
Boot done!

Preparing for write certificates...

Switching to CMT...

Erase NPC... Ok
Writing NPC... Ok

Erase CMT CCC... Ok
Writing CMT CCC... Ok

Erase CMT HWC... Ok
Writing CMT HWC... Ok

CMT cert write done!
Switch jaf to FBUS...
FbusMode set Ok


Writing SimLock Key... Error!
Writing SimLock Data... Error!
Writing Super Dongle Key... Ok
Product code update...

SDD Key status : SD Data is Ok
SimLock status : SimLock Damaged!!!!!
Security status : Security Damaged!!!!!

CMLA key sent... Ok
WMDRM_PD key sent... Ok

Done!

Connect phone on selected interface...

Phone found!
Series 60 Device detected!
read info... - Ok

лог mx-key:

Imei: 352xxxxxxxxxxxxxxxxxxx
Updating SIMLOCK(PA_SL3)...error 0x17
Trying to write SIMLOCK as PM(PA_SL3)...OK
Updating SUPERDONGLE_KEY ...OK
Updating CMLA_KEY ...OK
Updating WMDRM_PD ...OK
MXKEY [MxKey Team HTI Flasher Interface (WinUSB) 5], SN: C0844C4B
Using device: HTI, FW ver: 00.50, SN: 00001F9D
Connection status: UHCI:HUB:USB 2.00 (Full-speed)
Driver: WinUSB, ver: 3.5.1.0
Module ver: 1.0.0.21064(15-06-2012), Library ver: 1.0.0.14119(16-06-2012)
CMT Data :
SYSTEM ASIC ID: 000000030000022600010007600C192102011104 [RAPUYAMA ver: 1.1]
EM0 ID: 00001040
EM1 ID: 00001030
PUBLIC ID: 24D001173185034443A68C0C9FD987DBAB7B531B
ASIC MODE ID: 00
ROOT KEY HASH: 25B977A055BE9B5DEC0C38A2A279C695
ROM ID: 3E273BF637BE26FA
SecondaryBoot: RAPUv11_2nd.fg [BB5] version: 12.2.0 revision: 3.0 size: 0x3B40
Supported Ids: 4003192102001104, 400C192102001104, 6003192102001104, 600C192102001104, 6003192102011104, 600C192102011104, 6003192102021104, 600C192102021104, 6003192102031104, 600C192102031104
eBB5ProtocolType: NEW
TransmissionMode: DDR&TX2
Storage0: 0000 0000 - 0000 0000 type: RAM, asic:CMT
Storage1: FFFF 0000 - 0000 0000 type: MMC, asic:CMT
Storage2: 0000 0000 - 0000 0000 [unused/removed] type: FLASH,NOR, asic:CMT
Storage3: 0000 0001 - 0000 0000 [unused/removed] type: FLASH,NOR, asic:CMT
Storage4: 00EC 0058 - 0000 0121 [Samsung ] type: FLASH,MuxOneNAND, asic:CMT
Suggested algorithm: XSR 1.6
Algorithm: RAPUv11_XSR17_alg.fg [XSR 1.6] version: 12.2.0 revision: 3.0 size: 0xD44E9
Supported Ids: 4003192102001104, 400C192102001104, 6003192102001104, 600C192102001104, 6003192102011104, 600C192102011104, 6003192102021104, 600C192102021104, 6003192102031104, 600C192102031104
TransmissionMode: DDR&TX2
FUR: Adding Asic CMT as client OK
CMT PAPUBKEYS HASH: 5A598961FC04496A97031F5F80A2D25CECCF5577
Updating CMT NPC ...OK
Updating CMT CCC ...OK
Updating CMT HWC ...OK
Prog.status for Asic CMT ...
NAND: OK

Phone type: RM-658 (Nokia E73)
SW version: V ICPR82_10w22.13 25-03-11 RM-658 (c) Nokia
Imei plain: 352xxxxxxxxxxxxxxxxxxx
Product code: 0599015
Battery voltage: 4736 mV, current: 4 mA
Language Pack:
- not available.

SLPA ver[4]: PA_SL3/PA_SIMLOC30 (15 digit NCK)
warning: avoid SW Downgrade & manual erase to this phone !

SIMLOCK invalid!
SUPERDONGLE_KEY seems to be valid
CMLA_KEY seems to be valid
WMDRM_PD seems to be valid
SECURITY_TEST failed!


SIMLOCK_DATA corrupted!
SIMLOCK_DATA corrupted!

думаю дело в самом rpl не корректно рассчитан откривайте rpl пожалуста там мало столбик simlock data чем у других rpl проверте пожалуста