[UO5OQ]

Процедура раскодировки Xperia X10 несколько иная, чем просто кнопка Unlock в программе SETool.

q:
which s1 android based phones i can unlock using alternative security bypass ?

a:
you can use that method for
x10i, x10mini, s0-o1b, e10, e15, e16, u20 phones.
lt15, mt15, r800 and other msm8255-based phones require very simple testpoint to perform alternative security bypass.

q:
how to unlock s1 android based phones using alternative security bypass ?

a:
Here is procedure.

1.
make sure you have firmware with android 2.x, NOT 1.6.
firmware 2.3 is NOT supported, downgrade to 2.1.
flash required firmware, if needed.



2.
power on phone without sim card, go to menu->settings->applications->development, enable "usb debugging"
connect phone to PC, install drivers from setool2 distr ( drivers\ADB_Drivers)

hint:
i suggest to import DisableADBNumbering.reg (DisableADBNumbering.zip) , however that is not required.

3.
select proper phone model.
on settings check signed mode, use alternative security bypass, do full unlock instead usercode reset
press unlock

when prompted, detach phone, turn it on fully, connect it again.
( or you can leave phone on cable, then power it on manually )

when program tells "warming up...", manually power on phone fully, cause it will automatically enter charging mode.

after you see "GETTING ROOT ACCESS ..." DO NOT TOUCH PHONE until procedure complete.

НЕ ОТКЛЮЧАЙТЕ ТЕЛЕФОН ОТ КАБЕЛЯ ВО ВРЕМЯ ПРОЦЕДУРЫ раскодировки, ЭТО МОЖЕТ УБИТЬ ТЕЛЕФОН И ТОЛЬКО через JTAG можно будет восстановить его.
НЕ ВЫНИМАЙТЕ АККУМУЛЯТОР ИЗ ТЕЛЕФОНА , ВО ВРЕМЯ ПРОЦЕДУРЫ раскодировки, ЭТО МОЖЕТ УБИТЬ ТЕЛЕФОН И ТОЛЬКО через JTAG можно будет восстановить его.

possible problems:

you getting "err: 00000005","err: 00000002" during process.

solution:
disable antivirus, especially if you using "koshmarsky antivirus", i recommend Doctor Web
do NOT run setool2 from restricted accounts.
do NOT run setool2 from read-only media.

problem:
it can happen ( very unlikely, though ) that ADB server will not recognize phone after reboot

solution:
IF phone not detecting automatically and on status bar you can see "waiting for phone...", again - only in that case - disconnect phone from usb and connect it again, procedure should continue.

if not, well, repeat from start.

============================================
Процедура раскодировки s1 android через testpoint

q:
how to unlock s1 android based phones using alternative security bypass using testpoint?

a:
first, that is ONLY applicable to phones, based on msm8255 chipset - lt15,mt15,r800, some upcoming models.
Here is procedure.

1.
prepare for testpoint operation.
check testpoint location for your phone model in dist\docs\
open testpoint for access
get some needle with wire, connect it to phone gnd ( battery minus ) or to usb cable shield, etc.

2.
select proper phone model.
on settings check signed mode, use alternative security bypass, do full unlock instead usercode reset
fill login/password and check if account valid.

press unlock





when prompted, execute steps in EXACT order:

1. remove cable from phone,
2. remove battery from phone,
3. attach testpoint
4. press "ready"
5. insert cable to phone, HOLDING TESTPOINT
6. install drivers from dist\drivers\USBFlash_driver\
7. when prompted detach testpoint
8. press "ready"
9. phone will be unlocked.

Оригинал поста the_laser автора SETool >>>