card found:
registered to:
Connect phone on selected interface...
UFS S/N boot - Ok
Connect phone on selected interface...
Phone found!
Series 60 Device detected!
read info... - Ok
Checking StartUp data ...
-----------------------
SDD Key status : SDData Damaged!!!!!
- > Do REPAIR SDD , Local SX4 if needed
CMLA Key status : CMLA key Not exist
SimLock status : SimLock Damaged!!!!!
- > Do REPAIR SL if it SL2/SL phone, if SL3 - Help Only Backup Or RPL
Security status : Security Damaged!!!!!
- > Do Local SX4 or Server SX4 , Upload Tune ( checkbox or manual )
-----------------------
PA_SimLock Version :
PA_SL phone detected
Done!
Will Write RPL keys now...
Check RPL file...
NPC Data found! (CMT)
CCC Data found! (CMT)
HWC Data found! (CMT)
SIMLOCK Data found!
SIMLOCK KEY found!
SUPERDONGLE KEY found!
CMLA KEY found!
WMDRM KEY found!
Setting FlashMode
FlashMode set Ok
1st boot Ok, C0
CMT part info :
CMT ASICID : 000000030000022600010007600C192102011104
CMT EM0 ID : 00001040
CMT EM1 ID : 00001030
CMT PUB ID : 1DC00018C78C0344833A0CB46AFA1B2CC85C33B0
CMT MODE ID : 00
CMT R_HASH : 25B977A055BE9B5DEC0C38A2A279C695
CMT ROM ID : 3E273BF637BE26FA
CMT : Sending 2nd loader...
Use : RAPUv11_2nd.fg , Rev : 0.0 Ver : 1.37.1
CMT Loader sent, Boot Ok
MCU Configuration
MCU Cfg Ok , 03
FLASHID : 00400020 , CMT , NOR
CMT Flash ID : 00400020 < ST => M39BORBOAD
FLCNT : 000000FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : RAPUv11_algo_xsr16.fg , Rev : 0.0 Ver : 1.40.0
CMT Algo sent
PAPUBkeys blank (erased or HW failure)
Transmission mode : Dual (Ddr, TX2)
Boot Done!
Preparing for write certificates...
Switching to CMT...
CMT : CCC erase Ok
PrReq : Error , 00060E434343000000000000000000
PrReq : Error , 00060E434343000000000000000000
Writing CCC... Ok
CMT : HWC erase Ok
PrReq : Error , 00060E485743000000000000000000
PrReq : Error , 00060E485743000000000000000000
Writing HWC... Ok
Init Service mode... Wait...
Service mode init failed!
Check Cable/BSI/HW, try again
Connect phone on selected interface...
Phone found!
Series 60 Device detected!
read info... - Ok
Checking StartUp data ...
-----------------------
SDD Key status : SDData Damaged!!!!!
- > Do REPAIR SDD , Local SX4 if needed
CMLA Key status : CMLA key Not exist
SimLock status : SimLock Damaged!!!!!
- > Do REPAIR SL if it SL2/SL phone, if SL3 - Help Only Backup Or RPL
Security status : Security Damaged!!!!!
- > Do Local SX4 or Server SX4 , Upload Tune ( checkbox or manual )
-----------------------
PA_SimLock Version :
PA_SL phone detected
Done!
Local SX4 procedure started...
Check SD : Key Damaged!!!
SX4 Auth error
Local SX4 procedure started...
Check SD : Key Damaged!!!
SX4 Auth error
Connect phone on selected interface...
Reading Phone Info....
Connected phone - Nokia E52-1
Software ver : V ICPR82_11w16.3.11 29-03-12 RM-469 (c) Nokia
IMEI : 353785044877180
XappVer : 00000726
Ape Ver : 091.003
APE Var : 091.003091.003.05.01091.003.C00.01
APE ADSP: 256
DSP Ver : 11w52
APE Test: v0.a091
PPM :
CNT :
Product SN : MKO646753
Product code : 0586659
Base Prd.code: 0565921
Module code : 0203994
Long Prod.SN : 0
Hardware info=======
HWID : 6000
Retu : 40
Tahvo : 00
Batery: 4429 mV
APE HW: 256
RF ic : |Vapaus_5.1 | Aura_?.?
Lock info ===========
IMEI : 353785044877180
IMEI spNet :
IMEI svNet :
Unable to read Lock table...
User code : Crypted
MMC pwd : no any record found
UserDataExLevel : Low [Gallery] , FullFlash method
Done!
Phone found!
Series 60 Device detected!
read info... - Ok
Will Write RPL keys now...
Check RPL file...
NPC Data found! (CMT)
CCC Data found! (CMT)
HWC Data found! (CMT)
SIMLOCK Data found!
SIMLOCK KEY found!
SUPERDONGLE KEY found!
CMLA KEY found!
WMDRM KEY found!
Setting FlashMode
FlashMode set Ok
1st boot Ok, C0
CMT part info :
CMT ASICID : 000000030000022600010007600C192102011104
CMT EM0 ID : 00001040
CMT EM1 ID : 00001030
CMT PUB ID : 1DC00018C78C0344833A0CB46AFA1B2CC85C33B0
CMT MODE ID : 00
CMT R_HASH : 25B977A055BE9B5DEC0C38A2A279C695
CMT ROM ID : 3E273BF637BE26FA
CMT : Sending 2nd loader...
Use : RAPUv11_2nd.fg , Rev : 0.0 Ver : 1.37.1
CMT Loader sent, Boot Ok
MCU Configuration
MCU Cfg Ok , 03
FLASHID : 00400020 , CMT , NOR
CMT Flash ID : 00400020 < ST => M39BORBOAD
FLCNT : 000000EF000400000200611004000500A80700
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : RAPUv11_algo_xsr16.fg , Rev : 0.0 Ver : 1.40.0
CMT Algo sent
PAPUBkeys blank (erased or HW failure)
Transmission mode : Dual (Ddr, TX2)
Boot Done!
Preparing for write certificates...
Switching to CMT...
CMT : NPC erase Ok
PrReq : Error , 00060E4E5043000000000000000000
PrReq : Error , 00060E4E5043000000000000000000
Writing NPC... Ok
CMT : CCC erase Ok
PrReq : Error , 00060E434343000000000000000000
PrReq : Error , 00060E434343000000000000000000
Writing CCC... Ok
CMT : HWC erase Ok
PrReq : Error , 00060E485743000000000000000000
PrReq : Error , 00060E485743000000000000000000
Writing HWC... Ok
Init Service mode... Wait...
Service mode init failed!
Check Cable/BSI/HW, try again
Connect phone on selected interface...
Phone found!
Series 60 Device detected!
read info... - Ok
Checking StartUp data ...
-----------------------
SDD Key status : SDData Damaged!!!!!
- > Do REPAIR SDD , Local SX4 if needed
CMLA Key status : CMLA key Not exist
SimLock status : SimLock Damaged!!!!!
- > Do REPAIR SL if it SL2/SL phone, if SL3 - Help Only Backup Or RPL
Security status : Security Damaged!!!!!
- > Do Local SX4 or Server SX4 , Upload Tune ( checkbox or manual )
-----------------------
PA_SimLock Version :
PA_SL phone detected
Done!
Setting FlashMode
FlashMode set Ok
1st boot Ok, C0
CMT part info :
CMT ASICID : 000000030000022600010007600C192102011104
CMT EM0 ID : 00001040
CMT EM1 ID : 00001030
CMT PUB ID : 1DC00018C78C0344833A0CB46AFA1B2CC85C33B0
CMT MODE ID : 00
CMT R_HASH : 25B977A055BE9B5DEC0C38A2A279C695
CMT ROM ID : 3E273BF637BE26FA
CMT : Sending 2nd loader...
Use : RAPUv11_2nd.fg , Rev : 0.0 Ver : 1.37.1
CMT Loader sent, Boot Ok
MCU Configuration
MCU Cfg Ok , 03
FLASHID : 00400020 , CMT , NOR
CMT Flash ID : 00400020 < ST => M39BORBOAD
FLCNT : 0000000000000000000062FFFFFF0000A80700
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : RAPUv11_algo_xsr16.fg , Rev : 0.0 Ver : 1.40.0
CMT Algo sent
PAPUBkeys blank (erased or HW failure)
Transmission mode : Dual (Ddr, TX2)
Boot Done!
Erasing selected certificates...
CMT : NPC erase Ok
PrReq : Error , 00060E4E5043000000000000000000
CMT : CCC erase Ok
PrReq : Error , 00060E434343000000000000000000
CMT : HWC erase Ok
PrReq : Error , 00060E485743000000000000000000
Cert erased ok
Connect phone on selected interface...
Will Write RPL keys now...
Check RPL file...
NPC Data found! (CMT)
CCC Data found! (CMT)
HWC Data found! (CMT)
SIMLOCK Data found!
SIMLOCK KEY found!
SUPERDONGLE KEY found!
CMLA KEY found!
WMDRM KEY found!
Setting FlashMode
FlashMode set Ok
1st boot Ok, C0
CMT part info :
CMT ASICID : 000000030000022600010007600C192102011104
CMT EM0 ID : 00001040
CMT EM1 ID : 00001030
CMT PUB ID : 1DC00018C78C0344833A0CB46AFA1B2CC85C33B0
CMT MODE ID : 00
CMT R_HASH : 25B977A055BE9B5DEC0C38A2A279C695
CMT ROM ID : 3E273BF637BE26FA
CMT : Sending 2nd loader...
Use : RAPUv11_2nd.fg , Rev : 0.0 Ver : 1.37.1
CMT Loader sent, Boot Ok
MCU Configuration
MCU Cfg Ok , 03
FLASHID : 00400020 , CMT , NOR
CMT Flash ID : 00400020 < ST => M39BORBOAD
FLCNT : 00000000000000000000000000000000000000
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : RAPUv11_algo_xsr16.fg , Rev : 0.0 Ver : 1.40.0
CMT Algo sent
PAPUBkeys blank (erased or HW failure)
Transmission mode : Dual (Ddr, TX2)
Boot Done!
Preparing for write certificates...
Switching to CMT...
CMT : NPC erase Ok
PrReq : Error , 00060E4E5043000000000000000000
PrReq : Error , 00060E4E5043000000000000000000
Writing NPC... Ok
CMT : CCC erase Ok
PrReq : Error , 00060E434343000000000000000000
PrReq : Error , 00060E434343000000000000000000
Writing CCC... Ok
CMT : HWC erase Ok
PrReq : Error , 00060E485743000000000000000000
PrReq : Error , 00060E485743000000000000000000
Writing HWC... Ok
Init Service mode... Wait...
Service mode init failed!
Check Cable/BSI/HW, try again
Connect phone on selected interface...
Phone found!
Series 60 Device detected!
read info... - Ok
Phone disconected!
Connect phone on selected interface...
Phone found!
Series 60 Device detected!
read info... - Ok
Checking StartUp data ...
-----------------------
SDD Key status : SDData Damaged!!!!!
- > Do REPAIR SDD , Local SX4 if needed
CMLA Key status : CMLA key Not exist
SimLock status : SimLock Damaged!!!!!
- > Do REPAIR SL if it SL2/SL phone, if SL3 - Help Only Backup Or RPL
Security status : Security Damaged!!!!!
- > Do Local SX4 or Server SX4 , Upload Tune ( checkbox or manual )
-----------------------
PA_SimLock Version :
PA_SL phone detected
Done!
Phone disconected!
Connect phone on selected interface...