[Cik]

Добрый день, принесли недавно P970 с графическим кодом я его попытался прошить но прошивка не пошла, и телефон не включается потребление играет от 18 до 28 вот лог прошивки, мне интересно могла ли повлиять прошивка так на телефон то что на нем замыкание вышло, после этого я разобрал телефон и через блок питания проверил где нагревается, то ли питание то ли флеш греется, что посоветуете делать и как объяснить клиенту доходчиво

28:51.141 Flashing firmware from <b>D:/Прошивки/LG/P970/LGP970AT-00-V20b-CIS-YYY-MAR-05-2012+0_AP.sbf</b>
28:51.158 Disconnect the cable from the handset, remove accumulator, wait five seconds and insert the cable into the handset
28:51.161 The hanset should go into download mode. If it has not happen ant the handset has started booting in normal mode repeate the action
29:01.512 SetupDiEnumDeviceInfo failed
29:01.512 Connect fail: data port: setup error:SetupDi Enum Device Info
29:01.722 SetupDiEnumDeviceInfo failed
29:01.722 Connect fail: data port: setup error:SetupDi Enum Device Info
29:01.941 SetupDiEnumDeviceInfo failed
29:01.942 Connect fail: data port: setup error:SetupDi Enum Device Info
29:02.167 Device found
29:02.440 File reported model: P970
29:02.441 Cp firmware is not found. Skip flashing cp-part
29:02.442 Flashing AP part of the phone
29:02.684 File reported model: P970
29:03.705 Partittion gpt1 addr 0 total 0x20000 used 0x20000
29:04.000 Partittion x-loader addr 20000 total 0x20000 used 0x20000
29:04.111 Partittion u-boot addr 40000 total 0x80000 used 0x60000
29:09.219 GetOverlappedResult failed
29:09.219 flashData failed
29:14.233 flashData failed
29:14.234 Partittion boot addr c0000 total 0x600000 used 0x500000
29:14.383 GetOverlappedResult failed
29:14.384 Command 04000000000600000000 failed
29:14.385 Error: Protocol: Invalid response:Partition init query has failed at address 0x000c0000
30:17.101 Flashing firmware from <b>D:/Прошивки/LG/P970/LGP970AT-00-V20b-CIS-YYY-MAR-05-2012+0_AP.sbf</b>
30:17.111 Disconnect the cable from the handset, remove accumulator, wait five seconds and insert the cable into the handset
30:17.113 The hanset should go into download mode. If it has not happen ant the handset has started booting in normal mode repeate the action
30:17.345 File reported model: P970
30:17.345 Cp firmware is not found. Skip flashing cp-part
30:17.347 Flashing AP part of the phone
30:17.577 File reported model: P970
30:22.587 Command 01000000000000000000 failed
30:22.588 Error: Protocol: Invalid response:Initialization query has failed