Показать сообщение отдельно
Старый 08.12.2011, 10:56   #1
Shuhauz
Senior Member
 
Аватар для Shuhauz
 
Регистрация: 19.04.2011
Сообщений: 304
Вес репутации: 79
Shuhauz is a jewel in the roughShuhauz is a jewel in the roughShuhauz is a jewel in the roughShuhauz is a jewel in the rough
Отправить сообщение для Shuhauz с помощью ICQ
По умолчанию Прошивка через Usb Cyclon box

Всем привет!После обновление бокса почему то я не могу прошить или стереть через USB.Кто нидь знает в чем косяк?Те которые ошибки показывает бокс смотрел не помогает.Вот лог The ROM Refused to start Secondary Loader. Common Reasons:
1. Battery voltage is too low.
2. Transmission error occured. Usually happens when You put battery on while USB cable plugged. Try unplug USB cable, re-insert battery, plug USB Cable.
3. Check USB cable quality, connect to USB 2.0 Port
4. It may be also phone hardware problem
5. Also, loader may be corrupted, or current BootROM don't support it (affected are RAP3Gv3 and RAPIDO phones)
Failed to Full Erase BB5 -> Failed to Boot / Prepare Phone
Shuhauz вне форума   Ответить с цитированием