Preparing for write certificates...
CMT : CCC erase Ok
Writing CCC... Ok
CMT : HWC erase Ok
Writing HWC... Ok
Done!
Reading Phone Info....
Connected phone - Error
Software ver : Error
IMEI : Error
Ape Ver : Error
APE Var : Error
APE ADSP: Error
DSP Ver : Error
APE Test: Error
PPM : Error
CNT : Error
Product SN : Error
Product code : Error
Base Prd.code: Error
Module code : Error
Long Prod.SN : Error
Hardware info=======
HWID : Error
Retu : Error
Tahvo : Error
Batery: 8189 mV
Camera:
CMT BT: Error
APE BT: Error
APE HW: Error
LCDVer: Error
RF ic : Error
Lock info ===========
IMEI : Error
IMEI spNet :
IMEI svNet :
Unable to read Lock table...
Will Write RPL keys now...
Check RPL file...
NPC Data found! (CMT)
CCC Data found! (CMT)
HWC Data found! (CMT)
SimLock Data found!
SimLock key found!
SuperDongle Key found!
CMLA key found!
WMDRM key found!
Setting FlashMode
FlashMode set Ok
FlashMode set Ok
1st boot Ok, C0
CMT part info :
CMT ASICID : 000000030000022600010007600C192102011104
CMT EM0 ID : 00000C34
CMT EM1 ID : 00000C30
CMT PUB ID : 15200104675B0344F09A0135D3F0EA8327CBBC87
CMT MODE ID : 00
CMT R_HASH : 25B977A055BE9B5DEC0C38A2A279C695
CMT ROM ID : 3E273BF637BE26FA
CMT : Sending 2nd loader...
Use : RAPUv11_2nd.fg , Rev : 0.0 Ver : 1.37.1
CMT Loader sent, Boot Ok
MCU Configuration
MCU Cfg Ok , 03
FLASHID : 00400020 , CMT , NOR
CMT Flash ID : 00400020 < ST => M39BORBOAD
FLCNT : 0000003D0168304D30ABB5B101F018D1089902
FLASHID : 0000FFFF , CMT , MMC , EXT
CMT Flash ID : 0000FFFF < Bad Flash Type , if MMC - It Ok
Sending ALGO....
Use : RAPUv11_algo_xsr16.fg , Rev : 0.0 Ver : 1.40.0
CMT Algo sent
PAPUBkeys blank (erased or HW failure)
Transmission mode : Dual (Ddr, TX2)
Boot Done!
Preparing for write certificates...
Switching to CMT...
CMT : NPC erase Ok
Writing NPC... Ok
CMT : CCC erase Ok
Writing CCC... Ok
CMT : HWC erase Ok
Writing HWC... Ok
Init Service mode... Wait...
Writing SimLock Key... Error!
Writing SimLock Data... Error!
Writing Super Dongle Key... Ok
SDD Key status : read data error
SimLock status : SimLock Damaged!!!!!
Security status : Security Damaged!!!!!
Done!
Connect phone on selected interface...