Цитата:
Сообщение от UO5OQ
Можно не понижать, а использовать Test Point и SETool.
При использовании Test Point, версия не играет роли.
 |
Паша измени свою инструкцию, так как ни в коем случае нельзя ставить галочку на
use testpoint (gnd type) вчера ее поставил и прибил свое тело.
Сижу и думаю как его поднять.
Инструкция в оригинале how to unlock s1 android based phones, based on qsd8x55
1.
prepare for testpoint operation.
check testpoint location for your phone model in dist\docs\
open testpoint for access
get some needle with wire, connect it to phone gnd ( battery minus ) or to usb cable shield, etc.
2.
select proper phone model.
select USB as interface.
on settings check signed mode, use alternative security bypass, do full unlock instead usercode reset
fill login/password and check if account valid.
press unlock
when prompted, execute steps in EXACT order:
remove cable from phone,
remove battery from phone,
attach testpoint
press "ready"
insert cable to phone, HOLDING TESTPOINT
install drivers from dist\drivers\USBFlash_driver\
make sure that driver for qhusb_dload ( device, which will appear after successful testpoint ) is installed from dist\drivers\usbflash_drivers and named "ZEUS Flash Device".
Install driver manually, if testpoint driver named otherwise.
when prompted detach testpoint
press "ready"