Лог:
RM170p_0736.C01, Type: Flash Image, Algo: BB5, BB5 ALGORITHM
Searching for BootCode: Single Line 8Bit
RAP3Gv3_2nd.fg, Type: 2nd Boot Loader, Rev: 0.1.30.0, Algo: BB5
Flashbus Write baud set to 51Kbits
Flashbus Read baud set to 98Kbits
Using OLD BB5 FLASHING PROTOCOL
If software STUCK HERE with box TX LED lit, that means:
1. You have not attached yellow TX2 Adapter (IT IS REQUIRED FOR BB5 PHONES WHEN USING JAF/UFS CABLES!)
2. Your cable is not TX2 Enabled!
3. Transmission error occured, try again
In either cases, you need to reconnect your box from USB.
FlashChip[0,CMT]: 0x00EC220800008D21, Samsung, NOR
FlashChip[0,CMT]: 0x00EC003000000121, Samsung, ONENAND
Requested Algorithm: BB5 ALGORITHM (CMT)
FlashContent[0,CMT]: FFFFFFFFFFFFFFFFFFFFFFFFFFFFFFFF, NOR
FlashChip[0,CMT]: 0xFFFF000000000000, Unknown, MMC
Transmission Mode Requested: Single Line, 8 bit, Accepted: Single Line, 8 bit
Searching for BootCode: Single Line 8Bit
Processing Flash Image Failed -> Not found required Algorithm
Failed to Process all Image files -> Failed to process RM170p_0736.C01
Не смог прошить Е50